Ensurepass.com : Ensure you pass the IT Exams
2018 July Cisco Official New Released 210-060
100% Free Download! 100% Pass Guaranteed!
Implementing Cisco Collaboration Devices v1.0
Question No: 101
Which menu option should be selected to add a desk phone as an endpoint in Cisco Unified Communications Manager?
-
Application
-
Device
-
System
-
User management
-
Media devices
Answer: B
Question No: 102
An engineer has deployed IM-user-only mode for the IM and Presence Service. Which two features will be available? (Choose two.)
-
third-party XMPP clients are not supported
-
IM and Presence support without Cisco Unified Communications Manager
-
audio/video calling
-
Cisco Unity voicemail retrieval via SMTP
-
XMPP federation capabilities
Answer: B,E
Question No: 103
Which component is needed to facilitate the connection between Cisco Unified Communications Manager and Cisco Unified Presence Server?
-
SIP trunk
-
H.323 gateway
-
Gatekeeper
-
MGCP gateway
-
Cisco Unified Border Element
Answer: A
Question No: 104
Which configuration causes PSTN users to experience a fail tone for every other call when trying to reach a particular number on Cisco Unified CME?
-
ephone-dn is not assigned to the ephone.
-
Duplicate ephone-dn is not assigned to the ephone.
-
ephone is not registered.
-
ephone does not exist for the ephone-dn.
Answer: B
Question No: 105
Which three choices are required for the boot process for a Cisco IP phone? (Choose three.)
-
TFTP services
-
DHCP services
-
Voice VLAN
-
Routing protocol
-
TCP/IP
-
PortFast
Answer: A,B,C
Question No: 106
Which command is used to troubleshoot calls as they enter and leave a PRI connection?
-
Debug isdn q 931
-
Show voice call summary
-
Debug voip dialpeer
-
Show dial-peer voice summary
Answer: A
Question No: 107
Client A in X site uses an IP phone to call client B in Y site. Engineers have selected SCCP as the default VoIP signaling protocol. Which network path will the call signaling take when client A calls client B?
-
IP phone X gt; CUCM subscriber gt; IP phone Y using TCP port 1000
-
IP phone X gt; CUCM subscriber gt; IP phone Y using TCP port 2000
-
IP phone X gt; CUCM subscriber gt; IP phone Y using UDP port 1000
-
IP phone X gt; IP phone Y using TCP port 2000
-
IP phone X gt; IP phone Y using TCP port 1000
Answer: B
Question No: 108
A new user has successfully registered Cisco Jabber. Which option verifies that the Jabber client is connected to all appropriate back-end systems?
-
Show Connection Status
-
Report A Problem
-
Advanced Settings
-
About Jabber
-
Reset Jabber
Answer: A
Question No: 109
An engineer receives an isolated report that the customer can make calls successfully from an IP phone to other IP phones, but receives an error recording when attempting to call someone over the PSTN. The user cannot recall the error recording to provide the specific error message. Which two steps should the network engineer take to begin troubleshooting? (Choose two.)
-
Enable debug isdn q931 on the gateway and have user make the same call from the IP phone to PSTN again.
-
Check the region used by the IP phone in Cisco Unified Communications Manager.
-
Test the call using Dialed Number Analyzer in Cisco Unified Communications Manager administrator.
-
Check the calling search space used by the line on the IP phone in Cisco Unified Communications Manager.
-
Check the gateway to determine which codec is being used by the appropriate dial peer.
Answer: C,D
Question No: 110
What is needed to support SIP Early Media?
-
Media Termination Point
-
Transcoder
-
Annunciator
-
Conference Bridge
-
DSP
-
Route List
Answer: A