[Free] 2017(Jan) EnsurePass Braindumps Juniper JN0-692 Dumps with VCE and PDF 31-40

Ensurepass.com : Ensure you pass the IT Exams
2017 Jan Juniper Official New Released JN0-692
100% Free Download! 100% Pass Guaranteed!
http://www.EnsurePass.com/JN0-692.html

Service Provider Routing and Switching Support, Professional

Question No: 31 – (Topic 1)

Which two statements describe advantages of using BGP for VPLS signaling instead of LDP signaling? (Choose two.)

  1. There is no need for MPLS signaling protocol.

  2. There is a well-defined scaling hierarchy.

  3. There is a separation of signaling from other services.

  4. There is auto discovery.

Answer: B,D

Question No: 32 – (Topic 1)

You have recently added LDP-signaled VPLS to your network. The VPLS connections are established and you have been asked to verify that the forwarding plane is working properly. Which three commands would you use? (Choose three.)

  1. ping mpls Idp lt;fecgt;

  2. show vpls connections

  3. traceroute mpls Idp lt;fecgt;

  4. show vpls mac-table

  5. show Idp statistics

Answer: A,C,D

Question No: 33 – (Topic 1)

Click the Exhibit button.

Ensurepass 2017 PDF and VCE

R3 and R4 want to establish an EBGP session between each other#39;s loopback addresses. They have each configured static routes to the other#39;s loopback address and can ping from loopback to loopback. Their EBGP session is configured with correct neighbor and local addresses. The correct AS numbers have been specified at the [routing-options] hierarchy as well. Considering the topology in the exhibit, which statement is true?

  1. BGP#39;s protocol preference must be adjusted to be lower than protocol static for the session to establish.

  2. Each side must configure multipath for the session to establish.

  3. Each peer must specify a local-as within their EBGP configuration for the session to establish.

  4. Each peer must configure multihop for the session to establish.

Answer: D

Question No: 34 – (Topic 1)

Click the Exhibit button.

Ensurepass 2017 PDF and VCE

The output in the exhibit was captured on an interface. Which three statements are true about the configuration on the router with hostname SaoPaulo? (Choose three.)

  1. Wide metrics is not in use.

  2. The router has the overload bit set to quot;onquot;.

  3. Authentication is enabled.

D. System ID is 1921.6805.2001.

E. Level 2 routing is enabled.

Answer: A,C,E

Question No: 35 – (Topic 1)

Click the Exhibit button.

Ensurepass 2017 PDF and VCE

In the exhibit, on which label value does PE1 expect to receive traffic from CE3 for VPN A?

A. 2002

B. 3001

C. 3002

D. 2001

Answer: A

Question No: 36 – (Topic 1)

Which two configuration parameters are required to configure a BGP-signaled VPLS service? (Choose two.)

  1. vpls-id

  2. site-identifier

  3. route-distinguisher

  4. site-address

Answer: B,C

Question No: 37 – (Topic 1)

Click the Exhibit button.

Ensurepass 2017 PDF and VCE

The exhibit shows the output of a Junos show bgp neighbor command. Which two

statements are true? (Choose two.)

  1. IPv4 routes will be exchanged over this session.

  2. IPv6 routes will be exchanged over this session.

  3. The local router initiated the BGP session.

  4. BFD keepalive is configured to 30 seconds.

Answer: A,C

Question No: 38 – (Topic 1)

Click the Exhibit button.

Ensurepass 2017 PDF and VCE

R2 and R3 advertise a default route into Area 1.Based on the configurations in the exhibit, which statement is true? (Choose two.)

  1. Traffic from R1 to internal OSPF destinations in Area 0 will always transit R4.

  2. Traffic from R1 to internal OSPF destinations in Area 0 will always transit R2.

  3. Traffic from R1 to external OSPF destinations in Area 0 will always transit R2.

  4. Traffic from R1 to external OSPF destinations in Area 0 will always transit R4.

Answer: A,C

Question No: 39 – (Topic 1)

Click the Exhibit button.

Ensurepass 2017 PDF and VCE

R2 is announcing the 10.200/16 network to its IS-IS neighbors. No routing policies have been applied to R3. Referring to the exhibit, will R5 have 10.200/16 as an IS-IS route?

  1. Yes; IS-IS level 2 externals are passed from level 2 to level 1 by default.

  2. No; IS-IS level 2 externals are only passed to level 1 if wide-metrics-only is configured on all routers.

  3. Yes; all level 2 routing information is shared throughout an IS-IS domain by default.

  4. No; IS-IS does not announce routes from level 2 to level 1 unless a routing policy is

applied.

Answer: D

Question No: 40 – (Topic 1)

Click the Exhibit button.

Ensurepass 2017 PDF and VCE

What would happen if the guaranteed-rate command is removed from the configuration shown in the exhibit?

  1. The logical interface gets a minimal bandwidth reservation.

  2. The minimum-rate command should be configured instead.

  3. The logical interface receives no bandwidth constraints.

  4. The transmit-rate command should be configured instead.

Answer: A

100% Ensurepass Free Download!
Download Free Demo:JN0-692 Demo PDF
100% Ensurepass Free Guaranteed!
Download 2017 EnsurePass JN0-692 Dumps

EnsurePass ExamCollection Testking
Lowest Price Guarantee Yes No No
Up-to-Dated Yes No No
Real Questions Yes No No
Explanation Yes No No
PDF VCE Yes No No
Free VCE Simulator Yes No No
Instant Download Yes No No

2017 EnsurePass IT Certification PDF and VCE

Leave a Reply

Your email address will not be published. Required fields are marked *

This site uses Akismet to reduce spam. Learn how your comment data is processed.